Flott TB 10 plus Handbuch Seite 14

Mode drilling with depth control
- Chuck drill bit
- Clamp work piece
- Unlock emergency stop
- Close drill protection device
Set mode "Drilling"
(Display Drill Bit / LED Drilling)
Set speed(rpm) / control knob
Adopt speed(rpm) by pushing control knob
Feed drill bit on to work piece
mm
Push Zero adjustment button
Set drill depth by turning control knob
Adopt value by pushing control knob
- alternative: Set spindle to required drill depth (e.g. 8mm) by using lever
Adopt value by pushing control knob
Abort settings by pushing stop button
I
START
Spindle turns
1/min
Drilling
with display of drill depth
(when reaching nominal depth "beep")
mm
STOP
Change of drill settings spindle speed(rpm)
spindle speed(rpm) can be adjusted during downtime or operation by turning
control knob.
Change of drill settings zeropoint
Zeropoint (workpiece surface)can be adjusted during downtime or operation.
Change of drill settings drill depth
machine in operation
- Push control knob
- Set drill depth by turning control knob
- Adopt new drill depth by pushing control knob
- Now change of speed(rpm) is active again
212516 D/GB
GB
Display Drilling
flashes
Display flashes
X.X
Display flashes
X.X
value flashes
X.X
14