Starting Operation; Dust/Chip Extraction - IKEA FIXA Übersetzung Aus Der Ursprünglichen Anleitung

tools move freely. This results in radial
runout at no-load. However, this has no
effect on the accuracy of the drill hole, as
the drill bit centres itself during drilling.
The SDS tool holder can also accommodate
different drill-bit types with hexagon
shank. The dust protection cap (2) largely
prevents the entry of drilling dust into
the tool holder during operation. When
inserting the tool, take care that the dust
protection cap (2) is not damaged.
Inserting SDS plus Drilling Tools (see
figure A)
Clean and lightly grease the shank end of
the tool.
Insert the tool in a twisting manner into
the tool holder until it latches itself.
Check the latching by pulling the tool.
Removing SDS plus Drilling Tools (See
figure A)
WARNING! Accessories may be
hot after use. Avoid contact with skin and
use proper protective gloves or cloth to
remove.
Push back the locking sleeve (3) and
remove the tool. All accessories should be
wiped clean after removing.

Dust/Chip Extraction

Dusts from materials such as lead-
containing coatings, some wood types,
minerals and metal can be harmful to
one's health. Touch ing or breathing-in the
dusts can cause aller gic reactions and/or
lead to respiratory infec tions of the user or
bystanders.
Certain dusts, such as oak or beech dust,
are considered as carcinogenic, especially
in connection with wood-treatment
additives (chromate, wood preservative).
Materials containing asbestos may only be
worked by specialists.
Provide for good ventilation of the work ing
place.
It is recommended to wear a P2 filter class
respirator.
Observe the relevant regulations in your
country for the materials to be worked.

Starting operation

Setting the operating mode
With the selector switch for hammer
drilling/ drilling (4), the operating mode of
the machine is selected.
Note: Change the operating mode
only when the machine is switched off!
Otherwise, the ma chine can be damaged.
To change the operating mode, turn the
selector switch for "hammer drilling/
drilling" (4) to the re quested position.
Position for hammer drilling in con crete or
stone
Position for drilling without impact in wood,
metal, ceramic and plastic as well as for
screwdriving
Reversing the Rotational Direction
Actuate the rotational direction switch (5)
only when the machine is at a standstill.
10