Maintenance And Cleaning - IKEA FIXA Übersetzung Aus Der Ursprünglichen Anleitung

The rotational direction switch (5) is used
to re verse the rotational direction of the
machine. However, this is not possible with
the On/Off switch (6) actuated.
Right Rotation: For drilling and driving in
screws, push the rotational direction switch
(5) left to the stop.
Left Rotation: For loosening and
unscrewing screws and nuts, press the
rotational direction switch (5) through to
the right stop.
Switching On and Off
To start the machine, press the On/Off
switch (6) and keep it pressed.
To switch off the machine, release the On/
Off switch (6).
For low temperatures, the power tool
reaches the full hammer/impact capacity
only after a cer tain time.
Note: Sparks may be visible through
the slots in the motor housing during
operation. The sparks are a normal
reaction of the motor when in use and
are created by the components inside the
motor moving against each other. The
function of the power tool is not affected
by this. We do however recommend not
to use the power tool near any flammable
liquids, gases or dust, which the sparks
may ignite.
Setting the Speed/Impact Rate
The speed/impact rate of the switched
on pow er tool can be variably adjusted,
depending on how far the On/Off switch
(6) is pressed.
Light pressure on the On/Off switch (6)
results in low speed/impact rate. Further
pressure on the switch increases the
speed/impact rate.
Temperature Dependent Overload
Protection
When using as intended, the power tool
cannot be subject to overload. When the
load is too high or the allowable battery
temperature of 70 °C is exceeded, the
electronic control switches off the power
tool until the temperature is in the
optimum temperature range again.
Working Advice
Apply the power tool to the screw/nut
only when it is switched off. Rotating
tool inserts can slip off.

MAINTENANCE AND CLEANING

Before any work on the machine (e.g.
maintenance, tool change, etc) as well
as during transport and storage, set
the selector for rotation switch to the
centre position. Unintentional actuation
of the trigger can lead to injuries.
For safe and proper working, always
keep the machine and ventilation slots
clean.
ENVIRONMENTAL DISPOSAL
INSTRUCTIONS
Help to protect the environment
Information (for private households)
about the environmentally sound disposal
of electrical and electronic equipment in
accordance with the WEEE directive (Waste
Electrical and Electronic Equipment).
11 11