Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. OPERATING AND MAINTENANCE INSTRUCTIONS
3.1 Set up/short description
Our grill consists of a stainless steel housing (CrNi 1.4301) supported by a tubular frame. The bottom guide arm
(stainless, CrNi 1.4301) supporting the gyros skewer is welded to the tubular frame. The top guide arm which
also serves as the motor mount, is permanently connected to a heat shield. This heat shield protects the motor
and keeps it from overheating. The guide arm/heat shield unit is inserted into the guide tube which is mounted
at the tubular frame and tightened by means of the provided bolts. The guide arms are offset, thus assuring an
upright position of the skewer in the grill once the motor has been mounted.
3.2 Possible use
This grill is intended for commercial use only.
3.3 Important advices
Make sure that the protection foils and possible packaging remains are removed. Only persons who already read
the installation-, operating- and maintenance instructions respectively appropriated trained personal are
allowed to use this appliance. The grill in operation must never be unattended.
3.4 Start up
By opening the shut-off valve to the gas line or gas bottle, the grill is ready for use. Always ignite the top burner
first:
Turn the top knob to the highest setting (see diagram page 6) and press down. Ignite the gas as it exits the grating
of the top burner. Hold the knob pressed until the grating glows red (approx.. 20 sec.). At this point, the
temperature can be infinitely adjusted to the level desired. To start the other burners, repeat above procedure
using the appropriate knobs.
3.5 Motor operation
Attach the motor to the top guide arm using the top sliding sleeve, the fixing screw and the T-shaped countering
handle. Adjusting the motor angle is simple: loosen the countering handle, set the motor to the desired angle
en re-tighten the countering handle to secure the adjustment. Place the gyros skewer onto the bottom sliding
sleeve, adjusting the skewer angle until it is perpendicular with the ground. Slide the top sleeve up onto the
motor axle and insert the skewer head.
Slide the top sleeve back down again. Hang up the motor connection lead to the heat shield. Insert the shock-
proof plug into nearest available socket and set switch to position 1. Using the rocker switch on the motor
housing, the rotation direction can be set:
-
left hand rotation (press up on rocker switch)
-
off position (rocker switch in middle position)
-
right hand position (press down on rocker switch)
If you wish to change the distance between the heating surface and the meat being grilled, the fixing screw and
the countering handle for the top sliding sleeve must be loosened along with the fixing screw of the bottom
sliding sleeve. Move both sleeves together with the skewer until the desired distance is attained, making certain
that the meat surface is parallel to the heating surface. Then retighten the fixing screw and the countering handle.
3.6 Manual operation
The cross handle can also be separately delivered as a special spare part, so that the skewer can be used without
motor. After tightening the bottom fixing screw, place the gyros skewer onto the bottom sliding sleeve and adjust
skewer angle until it is perpendicular with the ground. Next, loosen the top fixing screw, position the top sliding
sleeve over the skewer head and then tighten the fixing screw. The cross handle can now be inserted from above
through the welded ring of the top sliding sleeve and onto the head of the skewer.
www.combisteel.com
8
Werbung
Inhaltsverzeichnis
