Operation; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL TC-CT 3,6 Li Originalbetriebsanleitung

If only the red LED fl ashes, the adapted charging
function is active. Reason: Exhaustive discharge.
For safety reasons the charging is performed less
quickly until the normal charge has been reached.
Note! The handle may become a little warm du-
ring the charging process. This is normal.
If the battery fails to charge, please check
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts of the charging unit
If the battery still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
5.2 Inserting the staples (Fig. 3)
•
Press the magazine slide (3) together using
your thumb and index finger.
•
Pull the magazine slide toward the rear of the
cordless stapler and out.
•
Fill the magazine with staples (b) as shown
in Fig. 3.
•
Then push the magazine slide back in until it
snaps noticeably into place.
Note!
It must be possible to move the magazine slide
without applying much force. Watch out for jam-
med staples.
Filling level indicator
The fi lling level indicator (4) shows you if there are
still enough staples in the magazine. If necessary,
refi ll the magazine as described above.
Avoid operating the trigger (1) if there are no stap-
les or nails in the magazine.

6. Operation

6.1 Operation (Fig. 3)
Before starting your work, always check the fi lling
level indicator (4) to see if the magazine contains
staples and is properly closed with the magazine
slide (3).
6.2 Triggering (Fig. 1)
The built-in trigger locks prevent the cordless
stapler from being triggered accidentally.
Triggering is only possible by pressing the head
(2) of the cordless stapler against the material
Anl_TC_CT_3_6_Li_SPK7.indb 15 Anl_TC_CT_3_6_Li_SPK7.indb 15
GB
and operating the trigger (1).
6.3 Indicator (Fig. 2/Item 7)
The indicator (7) indicates the battery charge le-
vel during charging (see section 5.1).
In addition, the green LED shines while the stap-
les are being stapled.
If the LED fl ashes red during operation, the batte-
ry is empty. Charge the battery.
7. Cleaning, maintenance and
ordering of spare parts
Hazard!
Never touch the head of the stapler while car-
rying out cleaning and maintenance work.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
7.2 Maintenance
There is a risk of staples becoming jammed par-
ticularly when the cordless stapler is held at any
angle when operated.
To remove them, pull the magazine slide (3) to-
ward the rear of the cordless stapler and out, and
carefully remove the jammed staples using sui-
table pliers. Push the magazine slide (3) back in
until it stops and snaps noticeably into place.
There are no other parts inside the equipment
which require maintenance.
- 15 -
04.09.15 13:37 04.09.15 13:37