Commissioning; Connecting The Ip Dect Server; Opening The Configuration Manager - Auerswald COMfortel WS-650 IP Betriebsanleitung

Commissioning

This section describes how to commission the device. This
includes the connection of the device, the logging onto the con-
figuration manager and an initial configuration.
Default Settings when the Equipment is Supplied
– Access data for the Configuration Manager:
User name: admin
í
Password: admin
í
(password before firmware version 14A: ip6000)
– Network settings:
DCHP enabled
í
– Network addresses (If no DHCP server is available in the
network):
IP address: 192.168.0.1
í
Network mask: 255.255.255.0
í

Connecting the IP DECT Server

Requirements
– Network cable
Insert one of the network cable's plugs in the RJ45 socket on
1.
the front of the device.
Insert the plug on the other end of the network cable into a
2.
network socket.
Connect the device to a mains power socket with protective
3.
earth.
The LED on the front cover flashes red followed by a
steady green if the IP DECT server has been configured.

Opening the Configuration Manager

Requirements
– Existing network connection between the PC and the IP
DECT server
– Knowledge of the IP DECT server's IP address
Note:
If a DHCP server is set up in the local network, the IP DECT
server will get its IP address from this DHCP server. You can
22
Commissioning
COMfortel WS-650 IP - Instructions V04 08/2017