Registering A Dect Handset To The Ip Dect Server - Auerswald COMfortel WS-650 IP Betriebsanleitung

Open the Users page.
1.
Click New.
2.
Under DECT, enter the DECT handset's IPEI in the IPEI
3.
entry field.
Format: 12-digit (consider space character!) xxxxx xxxxxxx.
In the Access code entry field, enter the access code that
4.
the DECT-handset should use to register to the IP DECT ser-
ver
In the Standby text entry field, enter a text that shows when
5.
the DECT handset is in idle state.
Under SIP, enter the internal telephone number for the
6.
DECT handset which you entered in the PBX in the User-
name/Extension entry field, e. g. 100.
In the Display name entry field, enter the telephone number
7.
you specified for the DECT handset in the PBX.
In the Authentication user entry field, enter the internal tele-
8.
phone number you specified for the DECT handset in the
PBX.
In the Authentication Password entry field, enter the pass-
9.
word you specified for the DECT handset in the PBX.
Click Save.
10.
Further steps
Set up additional DECT handsets.
Configure at least one COMfortel WS-Base multicell base
(see the instructions for the COMfortel WS-Base).
Note: To operate an IP-DECT Multicell System with the COMfor-
tel WS-650 IP you require at least one COMfortel WS-Base multi-
cell base.
Register the DECT handsets to the IP DECT server.
Registering a DECT Handset to the IP DECT
Server
Requirements
– Enabled Subscription allowed check box in the IP DECT
server's configuration manager under Configuration >
Wireless Server.
COMfortel WS-650 IP - Instructions V04 08/2017
Commissioning
25