Preparation; Rack-Mounting The Ip Dect Server - Auerswald COMfortel WS-650 IP Betriebsanleitung

This section describes the preparations required before commis-
sioning the device.

Rack-Mounting the IP DECT Server

The IP DECT Server is designed to be mounted in a 19" rack.
Requirements
– Tools and materials:
Screwdriver
í
The support bracket and screws included in the scope of
í
delivery
– Connections close to the mounting location:
Mains power socket with protective earth
í
Network socket
í
Warning: Liquid that penetrates the casing can cause
life-threatening electric shocks or can damage or destroy
the device.
Only operate the device in closed, dry rooms.
Caution: Overheating can damage or even destroy the
device.
Note the values given for ambient temperature and humidity
in the technical data.
Do not expose the device to direct sunlight.
Ensure that heat produced by the device can be adequately
vented into the environment. Do not install the system in a
cabinet without adequate air circulation.
Caution: Mechanical stress can result the damage or
destruction of the device or impairment of its functions.
Avoid mechanical loads (e.g. vibrations).
Protect the device from dirt, excessive dust, condensation,
caustic liquids, and steam.
Use 4 screws to attach the support brackets to the casing.
1.
Push the casing into the rack.
2.
Use 4 screws to secure the casing via the support brackets
3.
in the rack.
COMfortel WS-650 IP - Instructions V04 08/2017

Preparation

Preparation
21