Power Supply - Ferm TSM1035 Übersetzung Der Originalbetriebsanleitung

in doubt about the earth of the electricity
provisions, consult an electrician first.

Power supply

• The motor is fitted with an overload switch.
If the table saw overloads, the overload switch
switches the equipment off automatically to
protect the table saw from overheating. If the
overload switch triggers, switch off the table
saw using the ON/OFF switch (8) and wait
until the table saw cools down. Then press the
ON/OFF switch (8) and restart the table saw.
3. ASSEMBLY INSTRUCTIONS
Assembly undercarriage
Fig A4
First assembly all the parts and at the end tighten
the bolts,
• 1: Put the machine upside down, Put a piece
of cardboard underneath, so you don't
damage the subsurface.
• 2: Mount the legs (15) (4 pcs) with one
extension support (13) (4 pcs)per leg on the
four corners off the body, use longer bolts (16)
with nuts (2 pcs per leg) (Fig.B1)
• 3: Make sure the extension support (13) are
mounted same as shown in Fig.B1
• 4: Mount the cross strut (22) (4 pcs) between
the legs use small bolts (25) with nuts (16 pcs).
• 5: Place the rubber feet (23) (4 pcs)
• 6: Mount the additional legs (24) (2 pcs) on the
backside of the machine, use small bolts (26)
with nuts (4 pcs)
Assembly the extensions
Fig B1, Machine is still upside down
• Mount the extensions (3) (2 pcs) to the table,
use small bolts (17) with nuts (4 pcs).
• Mount the extensions support (13) to the
extensions (3), use small bolts (17) with nuts
(4 pcs)
• Turn the machine back on its feet. Make sure
the extensions are levelled with the table, by
using the slots in the extensions supports.
Assembly of the riving knife
Fig C
• Remove the inlay (21) from the table, by using
a screwdriver.
• Loosen the fixing screw (28)(Fig.C1)
• Raise the riving knife until the depth between
the saw table and the upper edge of the riving
knife equals approx. 110mm (Fig.C2)
• The distance between the riving knife and the
toothed rim of the saw blade must be between
3 and 5 mm.
• The tip of the riving knife shall not be lower
than 5 mm from the tooth peak, as shown in
Fig.C3
Attachment of the guard
Fig C4
• Turn sawblade completely upwards
(instructions for height adjustment see chapter 4)
• Pull the knob (19) of the guard (5) and place it
over the riving knife (20) while pulling the knob
• Release the knob and make sure the pin slides
in the hole
• Secure the guard by tighten the knob
Assembly the dust extraction
• Assembly dust extraction like shown on Fig.D
• Attach vacuum cleaner to (27) (Fig.D)
Attachment of the parallel guide
Fig E
• Attach the parallel guide (2) on the right side off
the saw blade on the table.
• Lock the guide down by pushing down the
handle (Fig.E)
Attachment of the mitre guide
Fig A1
• Slide the guide in the slot of the table at the left
side of the sawblade Fig.A1
Assembly or change the saw blade
Fig G
First remove the plug from the mains
before the saw blade is assembled or
replaced.
The arrow marked on the saw blade,
which indicates the direction of rotation,
must point in the same direction as the
arrow marked on the machine, the saw
blade teeth must point downwards on
the front of the saw.
11