Technical Specification - ZAPTEC ZapCharger Pro Benutzerhandbuch

Technical Specification

ZapCharger Pro is an alternating current
wall- or column-mounted charging station in
accordance with IEC 61851-1, EVSE mode 3.
Dimensions and weight
H: 392 mm, W: 258 mm, D: 1 12 mm
Weight: approximately 5 kg (including
backplate)
Installation network
TN, IT and TT
Installation circuit
Max 63A connected fuse on installation circuit
for charging stations.
Connection box
Cable cross section 2.5-10 mm2
Installation network, voltages
230VAC ±10%
400VAC ±10%
Max charging current and power
7.36 kW* at 32A single phase
22 kW* at 32A three phase (applies only to
TN networks)
Fuses
Built-in 3 x 40A type C fuses
Charging socket
IEC 62196-2 Type 2 Female
Earth fault protection
RCD type B
Soft start
Limits the inrush current at the start of charging.
eMeter
Integrated in the charging station with an
accuracy of +/-1 % on current and voltage.
This enables the user to check the actual power
usage. In an installation, the consumption report
can be used to distribute the cost based on use.
Theft protection
The front cover of the ZapCharger Pro can only
be opened with a special tool. The charging
cable can be permanently locked with the
charging station.
Phase distribution
In a system with other identical charging
stations, the units will select the least loaded
phase for one phase charging or use all three
phases for 3-phase charging.
Load distribution
In a system with other identical charging
stations, the power available in the installation
will be shared between the units by adjusting
the phase current and phase distribution
dynamically.
Communications interface and cloud
connection/network
WiFi 2.4 GHz, IEEE 802.1 1 b/g/n
(channels 1-1 1)
PLC – HomePlug Green PHY® (10 Mbit/s,
max. range of 300 m), compatible with other
products using the HomePlug standard
Identification and configuration
Bluetooth Low Energy (BLE 4.1)
RFID/NFC reader
Standards and approvals
CE in accordance with 2006/95/EC and
2004/108/EC
IEC 61851-1 – 2nd Edition
IEC 61851-22 – 1st Edition
Temperature range
-30°C to +50°C
EN
21