Cable Type For Zapcharger Pro; How To Start Charging; How To Start Charging With Authentication; How To End Charging - ZAPTEC ZapCharger Pro Benutzerhandbuch

Cable type for ZapCharger Pro

Your charging cable need to have type 2 plug in one end to connect to ZapCharger Pro charging
socket, the other plug should fit your vehicles specifications. Vehicle inlet adapters are accepted.

How to start charging

1. Check that the status indicator (Z) light is green.
2. Remove the protective cap to give access to the charging plug.
3. Plug the charging plug into the ZapCharger Pro.
4. Insert charging plug into the vehicle.
5. The status indicator (Z) flashes blue when the charging has started.
i
Charging current may vary depending on the capacity of your installation and numbers of users.

How to start charging with authentication

Charging with authentication require you have a registered user in ZapCloud and your user profile
has been permitted access (in ZapCloud) to the charging stations/installation you wish to use.
For setup of RFID tag/charge card see section Connect your RFID tag/charge card with your user.
1. Follow step 1-4 in How to start charging section.
2. To charge with ZapCharger app: login to the app and select charge now.
3. To charge with RFID tag/charge card: Status indicator is yellow to indicate you need to scan
your RFID tag/charge card
- Status indicator will now light yellow, Scan RFID tag/charge card on the charging station. See
illustration on ZapCharger Pro section for RFID zone.
- Status indicator will light green when authentication is approved.
4. Status indicator flashes blue when the charging has started.

How to end charging

1. To interrupt the charging process: Stop the charging process as recommended in the vehicle's
user manual.
2. Disconnect the charging plug from the vehicle.
EN
17