Klarstein 10030778 Bedienungsanleitung Seite 24

EN
24
Cord storage box
Put the power cord into the storage box when not use the machine which is in the back
of the machine. Do not wrap the cord around the appliance.
Hints for best Vacuuming Performance
• Do not put too much stuff inside the bag: leave enough empty space in the open
end of the bag so that the bag can be placed in the vacuum chamber area without
creating wrinkles or ripples;
• Do not wet the open end of the bag. Wet bags will cause difficulty to heat-seal
tightly.
• Do not leave too much air inside the bag. Press the bag to allow extra air to escape
from the bag before vacuuming it. Too much air inside the bag increases the
vacuum pump loading and may cause the motor insufficient power to draw away
all the air inside the bag.
• Do not vacuum packaging objects with sharp points like fish bones and hard shells!
Sharp points may penetrate and tear the bag! You may want to use a container
instead of a bag to store such stuff.
• Suggest to vacuum seal one bag within 1 minute, to let the appliance resume
enough.
• If it's not reach the required vacuum for some unknowable reason, the vacuum
system will shut automatically after 60 seconds, in this situation, please check if the
bag is leak, or not placed properly or any other reasons.
• Make sure there is no crack or deformation, or small particles resting on the foam
gaskets around the vacuum chamber. When this happens, take it out and wash and
dry it thoroughly, or replace with a new one.
• During bag vacuum packaging process, small amounts of liquids, crumbs or food
particles can be inadvertently pull into the vacuum chamber, clogging the pump
and damaging your appliance. To avoid this, freeze moist and juicy foods first
before sealing bags or place a folded paper towel near the inside top of the bag.
For powdery or fine-grained foods, avoid overfilling bags. You may also place a
coffee filter inside before vacuum packaging.
• Pre-freeze fruits and blanch vegetables before vacuum packaging for best results.
• Liquids need to be cooled before vacuum packing. Hot liquids will bubble up and
over the top of the jar when vacuum packed. Note: A jar attachment is necessary
for sealing jars.