Remote Master Mode Settings; Setting The Flash Mode On The Master Flash Unit - Metz mecablitz 52 AF-1 Bedienungsanleitung

10.1 Remote master mode settings

The slave group A is activated at the factory.
The master flash unit and slave groups A, B
and C can be activated or deactivated!
If the master flash unit is deactivated, it
only controls the slave units and does not
contribute to exposing the shot.
10.1.1 Remote master mode settings
• Switch on the flash unit with the
TTL
• Press the sensor button of the displayed
-7,9 m
0,7
m
Z
35 F4.0
OOM
m
EV
INFO
• Press the
GN
k
MASTER
SLAVE
• Press the
Remote master mode is shown in the picture.
REMOTE OFF
MASTER
The master does not make any contribution
4 —
A
to exposure (REMOTE MASTER off).
4 —
B
4 — If the master is to contribute to exposure,
C
then set the mode
INFO AIBIC
(see 10.1.2).
162
button. The start screen appears.
mode of operation on the touch display as
many times as it takes for the display for
selecting the mode of operation to appear.
sensor buttons on the
MASTER
touch display and select
MASTER
sensor button on the
touch display. Remote master mode is set.
Remote master mode is shown in the picture.
TTL M
or on the master
REMOTE
OFF
MASTER
4 —
A
4 —
B
4 —
C
INFO AIBIC
MASTER
MODE
EV
Off
TTL
M
. REMOTE TTL
MASTER
4 —
A
4 —
B
4 —
C
INFO AIBIC
10.1.2 Setting the flash mode on the master
flash unit
Off
• Press the sensor button
display as many times as it takes for the
master selection to appear.
MODE
• Press the sensor button on the
touch display.
• Use the sensor buttons
mode to "TTL" or "M".
• Press the sensor button on the touch
display for the desired mode of operation
TTL M
or alternatively .
The set mode of operation is adopted
immediately.
on the touch
to set the