Metz mecablitz 52 AF-1 Bedienungsanleitung Seite 159

Manual zoom mode
The zoom position of the reflector must be
adjusted manually to the lens focal length
when used with a camera that doesnít trans-
mit the data related to the lens focal length.
+
In this case auto-zoom mode is not possible!
After switching on the flash unit, „Zoom"
appears in the display and the current zoom
position of the reflector appears.
Setting procedure
• Press the
for the selection menu to appear.
• Press the
touch display.
• Press the
touch display and select "Zoom".
EV
• Press the
ZOOM
touch display.
• Press the
touch display and select the desired zoom
value.
50
After around 10 seconds, the operation
display appears, or press the
70
repeatedly until the operation display
85
appears. The following zoom positions are
possible for the reflector:
24 - 28 - 35 - 50 - 70 - 85 - 105 mm
(35 mm format).
D
button as often as it takes
PARA
sensor button on the
sensor buttons on the
Zoom
sensor button on the
sensor buttons on the
D
button
Tip:
If you do not necessarily need the full guide
number and maximum flash range of the
flash unit, you can leave the zoom reflector at
the position for the shortest focal length of
the zoom lens.
This will provide full light coverage of the
picture and eliminate the need to continually
adjust it to the focal length of the lens.
Example:
You use a zoom lens with a focal length range
of 35 mm to 105 mm. In this case, you set
the position of the reflector of the flash unit
to 35 mm.
k
159