Manual Flash Mode - Metz mecablitz 52 AF-1 Bedienungsanleitung

Some cameras do not support the BL func-
TTL BL
tion in combination with SPOT exposure
-3,5 m
0,3 metering! This flash mode "BL" will then eit-
her be automatically cancelled or cannot be
m
Z
35 F4.0
OOM
m
activated.
EV
INFO
In these cases, the normal TTL flash mode

7.3 Manual flash mode

In the manual flash mode M , the flash unit
emits the full uncontrolled amount of light if
no partial light output has been selected. The
specific photographic situation can be taken
into account by adjusting the aperture set-
ting or by selecting a suitable manual partial
light setting.
The setting area ranges from P 1/1 to
P 1/128 in
M HSS
k
at which the subject is correctly lit (see 5.2).
154
TTL
will be set.
M
mode and P1/1 - P1/32 in
mode. The display shows the distance
Setting the mode of operation
• Switch on the flash unit with the
button.
The start screen appears. Thereafter, the
flash unit always switches on with the
TTL
mode of operation that was used last .
-7,9 m
0,7
• Press the sensor button of the displayed
m
Z
F4.0
35 mode of operation on the touch display as
OOM
m
many times as it takes for the display for
EV
INFO
selecting the mode of operation to appear.
TTL BL
M
• Press the
GN
touch display and select
• Press the
display.
M
7,9 m
• Set a suitable mode of operation on the
m
Z
camera, e.g. M.
35 F4.0
OOM
m
• Tap the shutter release to transfer data bet-
INFO 1/1
ween the flash unit and the camera.
+
Various cameras support manual flash mode
M only in the camera's M mode (manual).
In other camera models, an error message
appears in the display and the release is
locked.
sensor buttons on the
M
.
M
sensor button on the touch