Werbung
Verfügbare Sprachen
Verfügbare Sprachen
BACHMANN EUROPE PLC
LILIPUT hopes that your E10 model will give you a lot of pleasure.
1. Putting your model into operation
Carefully remove the locomotive in the blister pack from the box. Then open the blister
pack as shown in the example in Pic 1a/1b, remove the locomotive and place it on the
rails. The direct current model is suitable for a maximum voltage of 14 volts, the alternating
current variant can either be run analogously on 16 volts or digitally. Allow the locomotive
to run backwards and forwards at about half voltage for a few minutes. The vehicle is then
ready for use.
Picture 1a
Picture 1b
2. Looking after your model
In order to ensure that your model functions correctly over a long period your model should
be maintained at regular intervals.
To do this place the model, as shown in Pic 2, upside down on a soft surface but be careful
not to damage the parts inserted in the roof and the pantograph. Clean the wheel contacts
and the wheels using cotton wool buds soaked in spirit. Please do not turn the drive wheels
by hand in any circumstances. After cleaning, please use a drop of machine oil to lubricate
the bearing points shown in Pic. 2. Use commercially available oils and use a fine can-
8
Werbung
