Transport; Storage; Care And Maintenance - Kärcher NT 80/1 B1 MS Originalbetriebsanleitung

DANGER
Risk of explosion! When cleaning the vacu-
um cleaner and wiping out the waste, the
smoking ban must be observed.
 Turn the unit off (position "0").
 Remove the vacuumed material from
the appliance immediately after usage
and instantly dispose of without interme-
diate storage (refer to "Disposing of vac-
uumed material"). This must be done by
a competent or instructed person.
 Rinse out the accessory parts with wa-
ter if necessary and dry them.
 Rinse container, wash the angle and
deflector with water. Clean the elec-
trode of the filling level sensor by
means of a damp cloth.
 Replace the cartridge filter regularly or
in case of excessive soiling.
Dispose of of the vacuumed up dirt
Disposal options:
1 Burning the vacuumed material: The
vacuumed material is to be dried and
then freed from propellant residues by
burning it before it can be disposed of
as nonhazardous waste.
2 Discharging the vacuumed material as
hazardous waste.
Note: The vacuumed material must not be
disposed of in the public sewer without be-
ing filtered.
DANGER
Please follow the local regulations during
the disposal process.
After vacuuming up dusts of the
category M
Note: Empty and clean the vacuum cleaner
after every use and whenever necessary.
 Empty the container.
 Vacuum and wipe the appliance inside
and outside.
 Place the appliance in a dry room and
secure it from unauthorized use.
 While vacuuming the appliance, use at
least one vacuum cleaner of the same
or higher classification.
CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport it.
 When transporting or maintaining the
device, the suction opening must be
closed with the plug.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Care and maintenance

DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
Dust extracting machines are safeguards
for the prevention or elimination of hazards
defined in the regulations of BGV A1.
– In order to carry out maintenance work,
the user must disassemble, clean and
service the unit, in so far as this is pos-
sible without endangering maintenance
personnel and other persons. Suitable
precautions include decontamination
before the unit is disassembled. Pre-
cautions must be taken for local filtered
forced air ventilation at the place where
the unit is disassembled, the cleaning of
the maintenance surface and suitable
protection of the personnel.
– The outside of the unit should be
cleaned thoroughly and any harmful
substances removed. Alternatively, a
sealed coating may be applied before
the unit is removed from the danger ar-
ea. All unit parts are to be considered
contaminated when they are removed
from the danger area. To avoid distribu-
tion of the dust, you must take the ap-
propriate measures.
– 5
EN

Transport

Storage

15