Cleaning The Appliance; Proceed As Follows; Interior Fittings; Light - Bosch KAN series Montage- Und Gebrauchsanleitung

Cleaning the appliance

ã=
Warning
Never clean the appliance with a steam cleaner!
ã=
Caution
Do not use abrasive or acidic cleaning agents
■
and solvents.
Do not use scouring or abrasive sponges. The
■
metallic surfaces could corrode.
Never clean shelves and containers in
■
the dishwasher. The parts may become deformed!

Proceed as follows:

1. Before cleaning: Switch the appliance off.
2. Pull out the mains plug or switch off the fuse.
3. Take out the frozen food and store in a cool location.
Place the ice pack (if enclosed) on the food.
4. Clean the appliance with a soft cloth, lukewarm
water and a little pH neutral washing-up liquid.
The rinsing water must not run into the light.
5. Wipe the door seal with clear water only and then
wipe dry thoroughly.
6. After cleaning reconnect and switch the appliance
back on.
7. Put the frozen food back in the freezer compartment.

Interior fittings

To clean the equipment, all variable parts of
the appliance can be taken out (see chapter Variable
interior design).
Note
To take out and clean the containers, open the doors
fully beyond 90°.
Removing the container
Pull out container all the way, lift to detach it from
the holder and take out.
To insert the container, place on the telescopic rails
and push into the appliance. Attach the container by
pressing it down.

Light

Changing bulbs in the refrigerator
compartment and freezer compartment
1. Switch off the appliance with the On/Off button.
2. Pull out mains plug or switch off fuse.
3. Remove cover strip.
4. Change the bulb (Replacement bulb:
220-240 V a.c., E14 bulb holder, see defective bulb
for wattage).
5. Reattach the cover strip.
en
37