LaserLiner MultiMeter-PocketBox Bedienungsanleitung Seite 15

When measuring resistance, to avoid the risk of the results
!
of a measurement being distorted, there must be no traces of
dirt, oil, solder spray or other contamination on the test prods.
6 Continuity test
To test continuity, turn the rotary switch
to position „
switch once to activate the „Continuity
test" function.
Then connect the measuring contacts to
the object to be tested. A measured value
of < 30 ohms is recognised as continuity;
If „O.L." appears on the display instead
of a measured value, either the measuring
range has been exceeded or the
measuring circuit is not closed or has
been interrupted..
MultiMeter-PocketBox
" and press the „Mode"
black
1x
red
15
GB