Specifications; Additional Safety Rules - Makita HR3000C Bedienungsanleitung

ENGLISH
1 Bit grease
2 Bit shank
3 Bit
4 Chuck cover
5 Change lever
6 Shift lever
7 ''Rotation
with hammering''
symbol
8 Lock button
9 Pointer
0 ''Hammering only'' symbol

SPECIFICATIONS

Model
Capacities
Tungsten-carbide tipped bit ........................ 30 mm
Core bit ....................................................... 90 mm
Wood .......................................................... 30 mm
Steel ........................................................... 13 mm
-1
No load speed (min ) ............................... 360 – 720
Blows per minute ................................ 1,650 – 3,300
Overall length ............................................... 391 mm
Net weight ....................................................... 4.8 kg
• Due to our continuing program of research and
development, the specifications herein are subject
to change without notice.
• Note: Specifications may differ from country to
country.
Power supply
The machine should be connected only to a power
supply of the same voltage as indicated on the
nameplate, and can only be operated on single-phase
AC supply. They are double-insulated in accordance
with European Standard and can, therefore, also be
used from sockets without earth wire.
Safety hints
For your own safety, please refer to enclosed the
safety instructions.
Explanation of general view
q ''Rotation only'' symbol
w Loosen
e Tighten
r Side grip
t Switch trigger
y Adjusting dial
u Clamp screw
i Depth gauge
o Power-ON indicator lamp
(green)
p Service indicator lamp (red)

ADDITIONAL SAFETY RULES

HR3000C
1. Wear a hard hat (safety helmet), safety glasses
2. Be sure the bit is secured in place before
3. Under normal operation, the machine is
4. In cold weather or when the machine has not
5. Always be sure you have a firm footing. Be
6. Hold the machine firmly with both hands.
7. Keep hands away from moving parts.
8. Do not leave the machine running. Operate the
9. Do not point the machine at any one in the
10. When drilling or chipping into walls, floors or
11. Do not touch the bit or parts close to the bit
SAVE THESE INSTRUCTIONS.
a Screwdriver
s Brush holder cover
d Brush holder cap
f Screws
g Connector
h Black
j White
k Crank cap
l Hex wrench
; Hammer grease
z Drill chuck
and/or face shield. It is also highly recom-
mended that you wear a dust mask, ear pro-
tectors and thickly padded gloves.
operation.
designed to produce vibration. The screws
can come loose easily, causing a breakdown
or accident. Check tightness of screws care-
fully before operation.
been used for a long time, let the machine
warm up for several minutes by operating it
under no load. This will loosen up the lubrica-
tion. Without proper warm-up, hammering
operation is difficult.
sure no one is below when using the machine
in high locations.
machine only when hand-held.
area when operating. The bit could fly out and
injure someone seriously.
wherever ''live'' electrical wires may be
encountered, DO NOT TOUCH ANY METAL
PARTS OF THE MACHINE! Hold the machine
by the insulated grasping surfaces to prevent
electric shock if you drill or chip into a ''live''
wire.
immediately after operation; they may be
extremely hot and could burn your skin.
7