Specification; Ec Declaration Of Conformity - Mebus 10380 Bedienungsanleitung

SETTING ALARM 2
1. Press [AL. 2]
2. Press [ + ] or [ – ] to turn on / off the alarm function.
3. Press and Hold [AL. 2] button until the hour for
alarm is flashing
4. Set the hour by press [ + ] or [ – ] , and then press
[AL. 2] button to confirm.
5. Then, to set the minute by press [ + ] or [ – ] , and then
press [AL.2] button to confirm.
6. If you would like to leave the alarm display and show
calendar, press [MODE] to show calendar. If you
would like to switch to alarm 1 display, press [AL.2]
button.
SNOOZE FUNCTION
When the alarm is wake up, you are able to press
[SNOOZE] to off the alarm

SPECIFICATION

Main Unit
Proposed operation range : -5C to 50C
Humidity measuring range : 25% to 90% at 25%
Temperature resolution : 0.1C
Humidity Resolution : 1%
Battery : 1.5V AA x 2pcs
Remote Sensor Unit
Proposed operation range : -10C to 50C
Humidity measuring range : 25% to 90% at 25%
Temperature resolution :
Humidity Resolution : 1%
RF Transmission frequency : 433 MHz
Maximum No. of remote unit : 3
Sensing cycle : around 43 to
47 seconds
Battery : 1.5V AA x 2pcs
67
Albert Mebus GmbH & Co.
Bergische Str. 11
42781 Haan
RoHS
www.mebus-electronic.com
69
PRECAUTIONS
This product is engineered to give you years of
satisfactory service if you handle it carefully. Here are
a few precautions:
1. Do not immerse the unit in water.
2. Do not clean the unit with abrasive or corrosive
materials. They may scratch the plastic parts and
corrode the electronic circuit.
3. Do not subject the unit to excessive force, shock, dust,
temperature or humidity, which may result in
malfunction, shorter electronic life span, damaged
battery and distorted parts.
4. Do not tamper with the unit's internal components.
Doing so will invalidate the warranty on the unit and
may cause unnecessary damage. The unit contains no
user-serviceable parts.
5. Only use fresh batteries as specified in the user's
manual. Do not mix new and old batteries as the old
ones may leak.
6. Always read the user's manual thoroughly before
operating the unit.
- The content of this manual is subject to change
without further notice.
- Due to printing limitation, the displays shown in
0.1C
this manual may differ from the actual display.
- The contents of this manual may not be reproduced
without the permission of the manufacturer.
EC-DECLARATION OF CONFORMITY
This product contains the approved transmitter and
complies with the essential requirements of Article 3 of
the R&TTE 1999/5/EC Directives, if used for its
intended use and that the following standard(s) has/have
been applied:
Efficient use of radio frequency spectrum
(Article 3.2 of the R&TTE Directive)
applied standard(s)
Electromagnetic compatibility
(Article 3.1.b of the R&TTE Directive)
applied standard(s)
applied standard(s)
Additional information:
The product is therefore conform with the Low Voltage
Directive 73/23/EC, the EMC Directive 89/336/EC and
R&TTE Directive 1999/5/EC (appendix II) and carries
the respective CE marking.
RTTE Compliant Countries:
All EU countries, Switzerland CH
QA MANAGER : Q.Y.ZENG
K.S plastic factory
Guan Lan / Shen Shen / China
Attention: Please dispose of used unit and
batteries in an ecologically safe manner
CAUTION
68
Product : RCW416
EN 300 220-1,3:2000
EN 301 489-1,3:2000
EN 300 339:2000
70