Qlima D 510 Gebrauchsanweisung Seite 87

OPERATION
D 510 - D 512
Picture 5
D 516 - D 520
Picture 6
1 Insert the plug in the wall outlet, the unit will produce 3 beeping sounds.
2 -button to switch the device on, the louver will open (D516 - D 520). When
Press the
in auto mode, the adjustment button
hydrostat is adjustable from 40% to 80%.
The value increases by 5% each time you press the button. The display indicates the
set humidity (SET HUMIDITY) and also the relative humidity (ROOM HUMIDITY).
D516 - D 520
The device will show a blue indicating light around the control panel to show to the user
that the device is working.
The blue indicating light can be switched "off" or "on" by pressing the
same time. This will not influence the dehumidification performance of the device.
3 Ensure that the water container has been positioned correctly. If the
on when you use the device for the first time, remove the water container from the
device and replace it in the correct position.
When in auto mode, the device starts to dehumidify when the relative humidity in the
room is higher than the set value.
The device switches off automatically when the set value is reached (fan will continue in
low speed), and restarts when the humidity in the room rises again.
G
NOTE!
• For extra protection of the compressor the dehumidifier is programmed such
that the compressor can only restart when more than 3 minutes have past
since compressor has switched off.
• To optimise the dehumidification efficiency and to prevent possible
decolouring: always place dehumidifier away from direct sunlight.
is used to set the desired humidity level. The
and at the
-light switches
4
87