Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2 Place the section of hair between
the plates
A
line as you can, and then close
them.
Caution
Do not touch the plates as they are
7
very hot.
3 Hold the appliance in position until
the hair is heated.
– This takes a few seconds at the
most.
4 Guide the plates in a careful,
smooth movement away from the
head to the end of the section of
hair. Avoid making kinks in hair.
Notes
Repeat the procedure section by
7
section.
If you have thick hair, you might
7
have to repeat this procedure on
the same section several times.
5 After use, switch the appliance off
by pressing the On/Off button
for 2 seconds. The LCD
turns off. Then unplug the power
cord
.
C
Styling waves or
curls
1 Comb or brush out a section of
your hair about 3 cm wide, start-
ing at the neck.
2 4 ENGLISH
as close to the hair
light
B
2 Place the section of hair between
the plates
line as you can, and then close
them.
Caution
Do not touch the plates as they are
7
very hot.
3 Hold the appliance in position until
the hair is heated.
– This takes a few seconds at the
most.
4 Depending on the hair style, rotate
the appliance by 180° so that the
hair wraps around it at the height
of the heating plates
5 While rotating, slowly pull the ap-
pliance towards the ends of the
hair.
– A curl is formed once the
appliance has been pulled
down and over the ends of the
hair.
E
Note
Repeat the procedure section by
7
section.
6 After use, switch the appliance off
by pressing the On/Off button
for 2 seconds. The LCD
turns off. Then unplug the power
cord
.
C
as close to the hair
A
.
A
B
E
light
Werbung
Inhaltsverzeichnis
