Acoustic Signal; Operating The As Super 4 Digital; Needle Placement And Connecting To The Device; Switching On The Device - schwa-medico AS SUPER 4 digital Gebrauchsanweisung

26
schwa-medico Instruction Manual - AS SUPER 4 digital

Acoustic signal

The AS super 4 digital emits an acoustic signal at each change of settings,
switching ON/OFF and at the end of a therapy session.
To switch OFF the acoustic signal press simultaneously the key of channel 1
and channel 3 until the "beep" menu appears on the display. Press the E key
to switch ON and OFF the acoustic signal, press the key to get out of the
acoustic signal mode.

Operating the AS SUPER 4 digital

Needle placement and
connecting to the device
Connect the cables to the AS SUPER 4 digital unit.
Place the needles into the skin on the appropriate acupuncture points.
Connect each needle with the crocodile clips at the end of the cables. Please
clip at the lower part of the needles in order to keep the needles approximately
straight. The crocodile clip should not be in contact with the patient's skin.
Please note that you always need 2 needles per cable.

Switching ON the device

Press the key to switch ON the AS SUPER 4 digital.

Program selection

Program group
Select a program group (1.0 to 9.0) by pressing the P key.
To scroll through the program groups, press the P key as often as necessary
until you have selected the program group of your choice.
Once you have reached the last program group, you will return to the first
one.
Subprogram
Select a subprogram by pressing the E key.
To scroll through the subprograms, press the E key as often as necessary until
you have selected the subprogram of your choice.
Once you have reached the last subprogram, you will return to the first one.
Example: Selecting the program 2.2 (Han 3)
Turn ON the device by pressing the key.
Press the P key until 2.0 is shown on the upper left side of the display. You
have selected the program group no. 2.