Auto-Power Off - elv E/H-FeldMessgerät EH 100 Bedienungsanleitung

PEAK
By pressing the "HOLD/PEAK" button once briefly,
you can select the PEAK mode. In this mode the
current measured value is saved on the display.
However, as soon as a higher value is measured,
this is displayed immediately and saved (peak
value memory).
You can return to normal mode by briefly pressing
the "HOLD/PEAK" button twice.

5.3.2. Auto-power OFF

In normal mode the device is automatically
switched off approx. 5 minutes after the last button
is pressed. This Auto-power OFF function can also
be deactivated, e.g., for extended measurements
to determine a peak value (PEAK).
Change-over is performed by pressing the "ON/
OFF" and "E/H" buttons simultaneously when
switching on the device.
If the current condition is not known, you should
leave the device switched on for at least 5 minutes
prior to leaving it unsupervised during an extended
measurement. If the device remains switched on,
the Power-OFF mode is deactivated; the device
must then be manually switched off after use.
29