Initial Start-Up - K-FEE square Betriebsanleitung

Initial start-up

SAFETY INFORMATION
Before initial start-up, it is
imperative that you read the
safety information on pages 5-7.
NOTE
1. If the appliance has been
subjected to very cold tem-
peratures or frost, please wait at least
three hours before switching it on. Al-
low the appliance to warm up to room
temperature fi rst - malfunction hazard.
2. We recommend the use of a water
fi lter for long and optimum coffee en-
joyment. Please insert this only after
the initial start-up. Please read the
instructions on pages 12/13 for this
purpose.
Remove the water tank, fi ll it up with
1
fresh drinking water and reinsert it in the
appliance.
1
10
Connect the appliance to the power
2
supply, press the lever right down to the
bottom and place a collecting container
under the spout. The device automatically
switches over to off/standby mode.
2
WARNING
Before initial start-up, please
ensure that the mains voltage
complies with that stated on the
nameplate (underside of appliance).
If you press any of the buttons the
3
appliance will switch on and heat up.
All button symbols blink (see fi gure 3b).
After heating up, only the milk button
which has been used for rinsing is illumi-
nated.
3a
On