Herunterladen Inhalt Inhalt Diese Seite drucken

Migatronic PI 400 PLASMA Betriebsanleitung Seite 22

Vorschau ausblenden Andere Handbücher für PI 400 PLASMA:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

The reset procedure is as follows:
Switch off the machine and wait until display is
extinguished.
Press
the
following
simultaneously:
Switch on the machine and keep the above keys
pressed until the display shows "X.XX". Then release
the keys.
X.XX is the software version of program.
Reset to factory settings
of a single program
Select the program in question, then press
and keep pressed the
turning the encoder. The display will show the current
program number by flashing the segments to confirm
the reset. Then you can release the key pad and the
current program will be reset to factory settings (see
values above).
Exit from the USER menu
Open/Close the gas valve in order to purge
the torch, check the gas bottle and pressure
reducer. Press "A" to Open/Close the gas. Exiting the
USER menu will close the gas anyway.
Submenu for MMA procediment
Exit from submenu
Value of Hot Start
Value of Arc Power
key
pads
-key pad for 5secs. without
USER MENU
This menu is intended to permit advanced
settings and controls of machine.
To access the user menu, press the knob
seconds when the machine is not welding. Rotate the
encoder to point the desired option and activate the
selection by pressing "A".
To change the values of parameters press the knob
MMA and rotate the encoder. Press "A" to save the
data. The menu can be leaved by choosing "- - -"
with the "A" knob.
The following diagram display all parameters and
options of menu.
Submenu for PLASMA procediment
Exit from submenu
Pilot Arc Active
Controls the activation of Pilot Arc
during welding.
0: Arc always OFF
1: Arc ON only during slope-up and
2: Arc always ON (default)
Submenu for wire feeder
Exit from submenu
Active control of CWF
0 = no CWF (default)
1 = at least one CWF
22
slope-down
for 3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis