Safety Regulations; Layout And Items Supplied - EINHELL GC-HC 9024 T Originalbetriebsanleitung

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Explanation of the symbols on the equipment
(see Fig. 12)
1. Warning
2. Do not expose to rain or wet conditions.
3. Read the directions for use before operating
the hedge trimmer.
4. If the cable is damaged or cut, immediately
disconnect the power plug.
5. Wear eye, hearing and head protection.
6. Wear safety boots.
7. Wear safety gloves.
8. Disconnect the power plug before carrying
out maintenance, cleaning and repair work.
9. Keep all other persons away from the danger
zone.
10. Maintain a safety distance of at least 10 m
from overhead lines.
11. Watch out for falling and catapulting parts.
12. Direction of the chain movement and teeth
13. Maximum cutting length / chain speed
Anl_GC_HC_9024T_SPK7.indb 20 Anl_GC_HC_9024T_SPK7.indb 20
GB

2. Layout and items supplied

2.1 Layout (Fig. 1/2)
1. Saw unit
2. Steady grip
3. Handle
4. Cable strain relief
5. Mains power cable
6. Cutter guard
7. On/Off switch
8. Safety switch
9. Extension pole
10. Harness
11. Motor unit
12. Cutter bar
13. Saw chain
14. Protective cap
15. Lock release to allow handle adjustment
16. Hexagonal wrench
17. Allen wrench 4 mm
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Danger!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Original operating instructions
•
Safety instructions
- 20 -
05.09.2016 08:57:16 05.09.2016 08:57:16