Safety Regulations; Layout And Items Supplied - EINHELL GC-HC 90/2046 T Originalbetriebsanleitung

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
WARNING!
Read all safety warnings, instructions, illust-
rations and specifi cations provided with this
power tool. Failure to follow all instructions listed
below may result in electric shock, fi re and/or
serious injury.
Save all warnings and instructions for future
reference.
This appliance is not intended for use by persons
(including children) with reduced physical, sen-
sory or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Explanation of the symbols on the tool
(Fig. 21):
1. Warning!
2. Protect the tool from rain and damp!
3. Watch out for falling and catapulting parts.
4. Keep your distance.
5. Read the directions for use before operating
the tool!
6. Wear protective headgear, goggles and ear
muff s.
7. Wear safety gloves!
8. Wear sturdy, non-slip footwear.
9. If the cable is damaged or cut, disconnect the
power plug from the mains immediately.
10. Electric shock can cause fatal injury. When
holding the pole-mounted pruner, keep it well
away from overhead power cables.
Anl_GC_HC_90-2046_T_SPK13.indb 20
GB
11. Direction of the chain movement and teeth.
12. Maximum cutting length / chain speed
13. This tool complies with Protection Class II
(double-insulated)
14. Guaranteed sound power level: 108 dB

2. Layout and items supplied

2.1 Layout (Fig. 1/2)
1. Saw unit
2. Grip area
3. Safety lock-off
4. Handle
5. Shoulder strap
6. Mains power cable
7. On/Off switch
8. Turning element
9. Tube mount
10. Fastening screw
11. Extension tube
12. Cutter rail
13. Saw chain
14. Motor unit
15. Cable strain-relief clip
16. Hand guard
17. Harness holder
18. Lock release to allow handle adjustment
19. Oil tank cap
20. Chain wheel cover
21. Cutter rail guard
22. Multifunction tool (size 13/4 mm)
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
- 20 -
09.11.2022 15:08:58