K8-Ai8 Technical Specifications; Electrical; Mechanical - Klein + Hummel K8-AI8 Bedienungsanleitung

K8-AI8 Technical Specifications

Electrical

Frequency Response Frequency Response Frequency Response Frequency Response
Signal to Noise Ratio Signal to Noise Ratio Signal to Noise Ratio Signal to Noise Ratio
Input Input Input Input
Input Level Input Level
Input Level Input Level
Output Output
Output Output
Control Control
Control Control
Termination Switch Termination Switch
Termination Switch Termination Switch
Digital Audio Format Digital Audio Format Digital Audio Format Digital Audio Format
Latency Latency Latency Latency
Power Requirements Power Requirements Power Requirements Power Requirements
Front Panel Indicators Front Panel Indicators Front Panel Indicators Front Panel Indicators
Rear Panel Indicators Rear Panel Indicators
Rear Panel Indicators Rear Panel Indicators

Mechanical

Weight Weight
Weight Weight
Dimensions Dimensions
Dimensions Dimensions
Operating Temperature Range Operating Temperature Range
Operating Temperature Range Operating Temperature Range
K8 Rackmount Family User Manual
20 Hz – 22 kHz
>100dB(A)
Balanced analogue audio, XLR-1/4" female combo connector x 8
+22 dBu peak
-10 dbV to +4 dBu nominal input level adjustments
Two K8 bus outputs, each drives 200 meters
RS-485, DB-9 female connector, open published protocol
38400 Baud, 8 Data, 1 Stop, No Parity
Optional USB adaptor
Optional Ethernet adaptor
4-position DIP
48 kHz sampling rate, 24 bit, proprietary
½ millisecond worst case, analogue in to analogue out
100 – 240 Volt, 50-60Hz
15 Watts
IEC power cord connector
Power
Signal present, signal nominal level, signal peak level
OK, Wink
7 lbs / 3,2kg
EIA Standard 19" Rackmount, 1.75" high, 8 " deep
0...70°C
11
Page