Overview; Rack Mounting; Routing Capabilities; Stacking Input Devices - Klein + Hummel K8-AI8 Bedienungsanleitung

Sync LED Sync LED Sync LED Sync LED The Sync light glows when an EtherSound network is connected and locked.
Wink LED Wink LED Light blinks when turned on by remote control software. This light may be used to
Wink LED Wink LED
confirm that a device is being remote controlled.
EtherSound Link LED Indicates that a valid EtherSound device is connected to the K8-ESB and is EtherSound Link LED
EtherSound Link LED EtherSound Link LED
synchronized.
EtherSound Activity Indicates communication activity to the connected EtherSound device. EtherSound Activity
EtherSound Activity EtherSound Activity
LED

Overview

The K8-ESB is used for routing any available EtherSound audio channel onto any one of 16 channels on the
K8 digital distribution bus.

Rack Mounting

The K8-ESB requires the optional accessory K8-RMK rack mounting kit. Two units may be mounted side by
side.

Routing Capabilities

The K8 bus contains 16 audio channels, in two groups of 8. The software utility, EtherSound Monitor,
available from Auvitran.com, or any other EtherSound standard control program may be used to select
which of the available EtherSound channels are routed onto the K8 bus.

Stacking Input Devices

It is also possible to turn off 8 channels of a 16 channel device, such as the K8-ESB, and combine it with 8
channels of another audio input type, such as the K8-AI8 analog inputs.
th
The 4 CONFIG DIP switch on the K8-ESB is used to turn off transmission of channels 9-16, making it
function like any other 8 channel K8 input device.
Using a crossover cable connect the Out 2 of the first device to the K8 Out 1 of the second device. The K8
Out 1 of the first device is then used to drive the K8 bus.
K8-AI8 Analogue Input
TERM K8 Out 1
On
K8 Out 2
K8 Channel Inputs 1-8
K8-ESB Ethersound Bridge
K8 Out 1
CONFIG
On
K8 Out 2
K8 Channel Inputs 9-16
K8 Rackmount Family User Manual
Out to
Distribution
Cat 5 Crossover Cable
Not Used
K8-ESB EtherSound Bridge
CONFIG K8 Out 1
On
K8 Out 2
K8 Channel Inputs 1-8
K8-AI8 Analogue Input
K8 Out 1
TERM
On
K8 Out 2
K8 Channel Inputs 9-16
Out to
Distribution
Cat 5 Crossover Cable
Not Used
21
Page