Intended Use - VOLTCRAFT VC-330 Bedienungsanleitung

2. INTENDED USE

Current clamp for measuring and displaying electrical parameters in the range of the overvoltage
categories CAT II to max. 600 V and CAT III to max. 300 V against ground potential, in
accordance with EN 61010-1 and all lower categories.
• Measures DC and AC voltages to a maximum of 600 V
• Measures direct and alternating currents to a maximum of 100 A
• Measures resistances up to 20 MΩ
• Continuity test (<10 Ω acoustic)
• Diode test
• Measures capacitance up to 2 mF
• Non-contact alternating voltage measurement (NCV) ≥100 - 600 V/AC and ≤15 mm gap
The voltage in the measuring circuit must not exceed 600 V in CAT II and 300 V in CAT III.
The product must only be used with the specified battery type.
The measuring device must not be used when it is open, when the battery compartment is
open or when the battery compartment cover is missing. Measurements must not be made in
damp rooms or in adverse environmental conditions. Adverse environmental conditions include:
Moisture or high humidity, dust and flammable gases, vapours or solvents or thunderstorms or
other similar conditions such as strong electromagnetic fields etc.
Only use test leads that conform to the specifications of the measuring device.
For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you
use the product for purposes other than those described above, the product may be damaged.
In addition, improper use can cause hazards such as short circuiting, fire, electric shock etc.
Read the instructions carefully and keep them. Make this product available to third parties only
together with its operating instructions.
This product complies with the statutory national and European requirements.
29