Installation; Before The Installation; Built-In Hobs; Possibilities For Insertion - Electrolux EHS3920HOX Benutzerinformation

10 www.electrolux.com

8. INSTALLATION

WARNING!
Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Model .......................................
PNC .........................................
Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.

8.3 Connection cable

• The hob is supplied with a connection
cable.
• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05V2V2-F T min 90°C.
Speak to your local Service Centre.
8.4 Building In
min. 650 mm
55 mm
490 mm
40-50 mm
30 mm
A. supplied seal
B. supplied brackets

8.5 Possibilities for insertion

The panel installed below the hob must
be easy to remove and let an easy
access in case a technical assistance
intervention is necessary.
Kitchen unit with door
270 mm
A. Removable panel
B. Space for connections
Kitchen unit with oven
The electrical connection of the hob and
the oven must be installed separately for
safety reasons and to let easy remove
oven from the unit.
B
CAUTION!
Install the appliance only on
a worktop with flat surface.
30 mm
min 20 mm
A
(max 150 mm)
60 mm
B
A