Electrolux EHH3320FOK Benutzerinformation Seite 30

30 www.electrolux.com
Problem
Automatic Heat Up function
does not operate.
The heat setting changes
between two levels.
The sensor fields become
hot.
comes on.
comes on.
comes on.
and a number come on. There is an error in the hob. Disconnect the hob from
comes on.
Possible cause
The zone is hot.
The highest heat setting is
set.
Power management func-
tion is activated.
The cookware is too large
or you put it too near to the
controls.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is no cookware on
the zone.
The cookware is incorrect.
The diameter of the bottom
of the cookware is too small
for the zone.
There is an error in the hob
because a cookware boils
dry. Automatic Switch Off
and the overheating protec-
tion for the zones operate.
Remedy
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the
function.
Refer to "Daily use" chapter.
Put large cookware on the
rear zones if possible.
Deactivate the hob and ac-
tivate it again.
Refer to "Daily use" chapter.
Put cookware on the zone.
Use the correct cookware.
Refer to "Helpful hints and
tips" chapter.
Use cookware with correct
dimensions.
Refer to "Technical informa-
tion" chapter.
the electrical supply for
some time. Disconnect the
fuse from the electrical sys-
tem of the house. Connect
it again. If comes on
again, speak to an Author-
ised Service Centre.
Deactivate the hob. Re-
move the hot cookware. Af-
ter approximately 30 sec-
onds, activate the zone
again. If the cookware was
the problem, the error mes-
sage goes out. Residual
heat indicator can stay on.
Let the cookware become
sufficiently cool. Check if
your cookware is compati-
ble with the hob.
Refer to "Helpful hints and
tips" chapter.