What To Do If - IKEA RENLIG DWTI60 Bedienungsanleitung

ENGLISH
3
2
1
To remove filters B
and C, turn the
handle approxi-
mately 1/4 anti-
clockwise.
5
1
2
Put the filter system
in position. To lock
the filter system,
turn the handle
clockwise until it
locks in position.
Important! Do not remove the spray arms.

What to do if...

The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem yourself. If you cannot find a
solution to the problem yourself, contact your dealer or the After Sales Service.
Problem
• Continuous flash
of the light of the
running pro-
gramme.
• Intermittent au-
dible signal.
• 1 flash of the
end indicator
light.
4
A
Remove the flat fil-
ter A from the bot-
tom of the appli-
ance.
Possible cause
The water tap is blocked or fur-
red with limescale.
The water tap is closed.
The filter in the water inlet hose is
blocked.
If the holes in the spray arms become clog-
ged, remove remaining parts of soil with a
cocktail stick.
Long periods of non-operation
Do these steps when you do not use the ap-
pliance for a long period:
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Keep the door open to prevent un-
pleasant smells.
4. Keep the inner side of the appliance
clean (filters especially).
External cleaning
Clean the external surfaces of the appliance
and control panel with a damp soft cloth.
Only use neutral detergents. Do not use
abrasive products, scouring pads or sol-
vents (acetone, trichloroethylene etc...).
Frost precautions
Caution! Do not install the appliance
where the temperature is below 0 °C.
The manufacturer is not responsible for
damage because of frost.
If not possible, empty the appliance and
close the door. Disconnect the water inlet
hose and remove water from the water inlet
hose.
Clean the water tap.
Open the water tap.
Clean the filter.
16
Solution