English - Philips PR3083 Bedienungsanleitung

ENGLISH

6
Introduction
Read this user manual carefully before you use the straps for the BlueTouch Pain Relief Patch and
save it for future reference.
Intended use
These straps are intended to be used with the BlueTouch Pain Relief Patch, type number PR3092.
The BlueTouch Pain Relief Patch is a device that is intended to be used on the upper or lower back
and that can be positioned and adjusted on the treatment area by means of a fabric strap.
Important
- Use the BlueTouch Pain Relief Patch in one of the Philips straps that has been specially designed
for it. The straps are not supplied with the patch and have to be obtained separately.
- To prevent damage to the BlueTouch Pain Relief straps, wash them in a fine-mesh washing bag.
- PR3081/00, PR3081/01, PR3083/00, PR3083/01: are made of 85% polyester, 15% cotton.
- PR3081/02, PR3081/03, PR3083/02, PR3083/03: are made of 95% polyester, 5% elastane.
Explanation of symbols
- This symbol means: Wash at a temperature of 30°C max (Fig. 1).
- This symbol means: Do not bleach (Fig. 2).
- This symbol means: Do not tumble-dry (Fig. 3).
- This symbol means: Do not iron (Fig. 4).
- This symbol means: Do not dry clean (Fig. 5).
- This symbol means: Conforms to EC Directives. CE stands for 'Conformitéé Européenne' (Fig. 6).
- This symbol means "manufactured by' and provides the address of the legal manufacturer (Fig. 7).
- This symbol means that the material has been tested for harmful substances according to
Oeko-Tex standard 100 (Fig. 8).
®
- This symbol means that this strap is to be used on the lower back (Fig. 9).
- This symbol means that this strap is to be used on the upper back (Fig. 10).
Using your BlueTouch straps
The preferred method for fastening the Pain Relief Patch to the body is by means of one of the
BlueTouch Pain Relief straps. There is a special strap for treatment of the upper back and a special
strap for treatment of the lower back.
Note: Do not wear multiple layers of clothing or tight or thick clothing over the BlueTouch Pain Relief
Patch to prevent the device from switching off before the treatment has been completed. If you wear too
tight or thick clothing, the infrared sensor will measure a too high temperature and switch off the device.
Positioning the lower back strap
To place the BlueTouch Pain Relief Patch in the strap, follow the steps below.
1 Put the lower back strap and the BlueTouch Pain Relief Patch in front of you on a table. Slide
the left side of the BlueTouch Pain Relief Patch behind the elastic edge of the opening in the
strap. (Fig. 11)
2 Then slide the other end of the BlueTouch Pain Relief Patch behind the opposite elastic edge
of the opening so that the whole patch is inside the lower back strap. Check to make sure
that the LEDs are not covered by the material of the strap. If necessary, shift the BlueTouch
Pain Relief Patch a little (Fig. 12).
3 Remove clothing from the area to be treated.
Note: Make sure the skin in the area to be treated is clean, entirely dry and free from creams,
lotions and other cosmetics.