Setting And Starting Aprogramme; Setting Mode - AEG FAVORIT 55022 Benutzerinformation

34 www.aeg.com
D
A
3
SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come on.
If the control panel shows other condi-
tions, press and hold function buttons (B)
and (C) at the same time until the appli-
ance is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. To set a programme, keep the appli-
ance door ajar.
3. Press the on/off button to activate the
appliance.
4. Make sure that the appliance is in set-
ting mode.
5. Press the button of the programme
you want to set.
A B
30
20
C
B D
0
2 0
+
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
A
-
C
6. Close the appliance door. The pro-
Starting a programme with
delay start
1. Set the programme.
2. Press the delay button again and
3. Close the appliance door. The count-
CAUTION!
Use only detergents for dishwash-
ers.
• The programme duration flashes in
the display.
• The related programme indicator
comes on.
• The wash indicator comes on.
gramme starts.
• The display shows the programme
duration that decreases with steps
of 1 minute.
• The wash indicator stays on.
again until the display shows the delay
time you want to set (from 1 to 19
hours).
• The delay time flashes in the dis-
play.
• The delay indicator comes on.
down starts.
• The display shows the countdown of
the delay start that decreases with
steps of 1 hour.