AEG FAVORIT 55022 Benutzerinformation Seite 39

Problem
Dry water drop
stains on glasses
and dishes.
The dishes are wet.
The dishes are wet
and matt.
Activating the rinse aid
dispenser with the multitab
function activated
1. Press the on/off button to activate the
appliance.
2. Make sure that the appliance is in set-
ting mode. Refer to 'SETTING AND
STARTING A PROGRAMME'.
3. Press and hold function buttons (B)
and (C) at the same time until the indi-
cators above function buttons (A), (B)
and (C) flash.
4. Press function button (B) .
• The indicators above function but-
tons (A) and (C) go off.
• The indicator above function button
(B) continues to flash.
• The display shows the setting of the
rinse aid dispenser.
5. Press function button (B) to change
the setting.
6. Deactivate the appliance to confirm.
Possible cause
The quantity of detergent
was too much.
The released quantity of
rinse aid was not sufficient .
The quality of the detergent
can be the cause.
The programme had no
drying phase.
The rinse aid dispenser is
empty.
The quality of the rinse aid
can be the cause.
The quality of the combi
detergent tablets can be
the cause.
Off
On
Possible solution
Make sure that you add the
correct quantity of detergent
in the dispenser before you
start a programme.
Increase the released quanti-
ty of rinse aid.
Try a different brand of de-
tergent.
Set a programme with the
drying phase.
Make sure that there is rinse
aid in the rinse aid dispenser.
Try a different brand of rinse
aid.
• Try a different brand of
combi detergent tablets.
• Activate the rinse aid dis-
penser and use the rinse
aid together with the com-
bi detergent tablets.
7. Adjust the released quantity of rinse
aid.
8. Fill the rinse aid dispenser.
ENGLISH
39