Cleaning The Oven Door - Atag OX6411L Benutzerinformation

Removing the shelf supports
To clean the oven, remove the shelf
supports.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
1
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must point to
the front.

Cleaning the oven door

The oven door has three glass panels. You
can remove the internal glass panels to
clean them.
CAUTION! Do not use the
appliance without the glass
panels.
The direction in which you open
the door depends on your oven
model. You open the door from
the right side in some models
and from the left side in others.
2
1. Press the buttons at the sides of the
door trim (A) on the upper cover and
pull it upwards to remove it.
2. Hold the inner glass B tightly with both
hands and slide it upwards to remove it
from its initial position. Do the same
with the second glass panel.
Make sure that you tightly hold the
glasses to prevent them from falling.
3. Clean the door with a wet sponge and
rub it dry with a soft cloth. Do not use
steel wool, acids or abrasive cleaning
agents because they can damage the
surface.
When the oven door is clean, install the
glass panels in the opposite sequence. The
middle glass panel has a small dot on the
top and the second one has screen
printings. Make sure that you put the
middle glass panel in the correct seats. The
screen-printing zone must face the inner
19
A
B