Wiring Connection - Kenwood KDC-300UV Bedienungsanleitung

Wiring connection

Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring harness as
illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function
: Battery
A4 Yellow
: Power control
A5 Blue/White
: Ignition (ACC)
A7 Red
: Earth (ground) connection
A8 Black
B1 Purple ]
: Rear speaker (right)
Purple/black [ For 3-way crossover: Tweeter (right)
B2
Gray ]
B3
: Front speaker (right)
For 3-way crossover: Mid range speaker (right)
Gray/black [
B4
White ]
B5 : Front speaker (left)
For 3-way crossover: Mid range speaker (left)
B6 White/black [
Green ]
B7
: Rear speaker (left)
For 3-way crossover: Tweeter (left)
Green/black [
B8
Rear/ Front/ Subwoofer output
For 3-way crossover: Tweeter/ Mid Range/ Woofer output
Antenna terminal
Ignition wire (Red)
Unit
Battery wire (Yellow)
Fuse (10 A)
If no connections are made, do not let the wire come out from the tab.
Yellow (Battery wire)
Light blue/yellow
Red (Ignition wire)
(Steering remote control
wire)
Red (A7)
Blue/White
(Power control wire/
Antenna control wire)
Yellow (A4)
Brown
(Mute control wire)
ISO connectors
If your car does not have an ISO terminal :
We recommend installing the unit with a
commercially available custom wiring harness
specific for your car and leave this job to
professionals for your safety. Consult your car
audio dealer.
When connecting to an external amplifier,
connect its ground wire to the car's chassis to
avoid damaging the unit.
STEERING WHEEL
REMOTE INPUT
To the steering wheel remote control
REMOTE CONT
adapter
To the power control terminal when
ANT CONT
using the optional power amplifier or
P. CONT
to the antenna control terminal in the
vehicle
To the terminal that is grounded
MUTE
when the telephone rings or during
conversation ( 14)
(To connect the Kenwood navigation
system, refer your navigation manual.)
ENGLISH
17