Dismantling And Disposal; Safety - Helios F300 Betriebsanleitung

10 Dismantling and disposal

10.1 Safety

Electrical system
Incorrect dismantling
10.2 Dismantling and disposal
After the end of service, the machine has to be dismantled and
disposed of in an environmentally-friendly manner.
DANGER!
Danger of death due to electrical current!
refer to chapter .
WARNING!
Danger of injury due to incorrect dismantling!
– Ensure that there is sufficient space for assembly
before beginning any work and handle open, sharp
edged components with care.
– Pay attention to tidiness and cleanliness at the place
of assembly! Loosely positioned components or
those left lying around are potential sources of acci-
dents.
– Mount the components professionally. Pay attention
to the heavy weight of the actual component. Use
lifting equipment if necessary.
– Secure components so that they cannot fall down or
fall over.
– Contact the manufacturer in case of any uncer-
tainty.
Prerequisites:
n Switch the machine off and secure it against being switched back
on.
n Physically disconnect the full energy supply from the machine
and discharge the stored residual energy. Remove any materials
and aids as well as any residual processing materials and
dispose of them in an environmentally-friendly manner.
To finish, professionally clean modules and components and
dismantle under compliance with the valid local work safety and
environmental protection regulations.
Dismantling and disposal
43