Husqvarna Master 46 Betriebsanleitung Seite 7

Preparation
1. Do not mow barefoot or in open sandals.
Always wear suitable clothing, gloves, and
stout shoes.
2. The use of ear protection is recommended.
3. Make sure the lawn is clear of sticks,
stones, bones, wire and debris; they could
be thrown by the blade.
4. Before using always visually inspect to see
that blades, blade bolts and cutter assembly
are not worn or damaged. Replace worn or
damaged blades together with their fixings
in sets to preserve balance.
5. Have faulty silencers replaced.
Use
1. Do not operate the engine in a confined
space where exhaust fumes (carbon
monoxide) can collect.
2. Use the lawnmower only in daylight or good
artificial light.
3. Avoid operating your lawnmower in wet
grass, where feasible.
4. Take care in wet grass, you may lose your
footing.
5. On slopes, be extra careful of your footing
and wear non-slip footwear.
6. Mow across the face of slopes, never up
and down.
7. Exercise extreme caution when changing
direction on slopes.
8. Mowing on banks and slopes can be
dangerous. Do not mow on banks or steep
slopes.
9. Do not walk backwards when mowing, you
could trip.Walk never run.
10. Never cut grass by pulling the mower
towards you.
11. Release the Operator Presence control to
stop the engine before pushing the mower
across surfaces other than grass and when
transporting the lawnmower to and from the
area to be mowed.
12. Never operate the lawnmower with
damaged guards or without guards in place.
13. Do not overspeed the engine or alter
governor settings. Excessive speed is
dangerous and shortens lawnmower life.
14. Disengage all blade and drive clutches
before starting.
15. Always start the lawnmower carefully with
feet well away from the blades.
16. Do not tilt lawnmower when starting the
engine
SAFETY PRECAUTIONS
17. Never pick up or carry a lawnmower while
18. Spark plug wire may be hot - handle with
19. Do not attempt any maintenance on your
20. Release the Operator Presence Control, to
-
21. Release the Operator
-
-
-
-
-
Maintenance and storage
1. Keep all nuts, bolts and screws tight to be
2. Replace worn or damaged parts for safety.
3. Only use the replacement blade, blade bolt,
4. Never store the lawnmower with fuel in the
5. Allow the engine to cool before storing in
6. To reduce fire hazard, keep the engine,
7. If the fuel tank has to be drained, this
8. Be careful during adjustment of the machine
the engine is running
care.
lawnmower when the engine is hot.
stop the engine, and wait until the blade has
stopped:-
before leaving the mower unattended for
any period.
Presence Control, to stop
the engine, wait until the
blade has stopped and
disconnect the spark plug
lead and wait until the
engine has cooled:-
before refuelling;
before clearing a blockage;
before checking, cleaning or working on the
appliance;
if you hit an object. Do not use your
lawnmower until you are sure that the entire
lawnmower is in a safe operating condition;
if the lawnmower starts to vibrate
abnormally. Check immediately. Excessive
vibration can cause injury.
sure the lawnmower is in safe working
condition.
spacer and impeller specified for this
product.
tank inside a building where fumes can
reach an open flame or spark.
any enclosure.
silencer, battery compartment and fuel
storage area free of grass, leaves or
excessive grease.
should be done outdoors.
to prevent entrapment of the fingers
between moving blades and fixed parts of
the machine.
2 - ENGLISH