Küppersbusch IKE2380-1 Benutzerinformation Seite 27

Problem
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after press-
ing the FastFreeze, or after
changing the temperature.
The compressor does not
start immediately after press-
ing the IntensiveCooling, or
after changing the tempera-
ture.
Water flows inside the refrig-
erator.
Possible cause
The temperature in the ap-
pliance is too high.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The FastFreeze function is
switched on.
The IntensiveCooling func-
tion is switched on.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent that
water flows into the water
collector.
Solution
Contact a qualified electrician
or contact the nearest Author-
ized Service Centre.
Close and open the door.
Contact the nearest Authorized
Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "FastFreeze function".
Refer to "IntensiveCooling func-
tion".
Wrap the food products better.
Refer to "Operation" chapter.
The compressor starts after a
period of time.
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
27