Other Mode; Dmx-Mode; Dmx-Protocol - EuroLite LED SLS-12 BCL Bedienungsanleitung

Other mode

In this mode there are 3 sub-menus to choose from. Please press the SET UP button to reach the selection,
as appropriate.
At and
if it should turn off after 60 seconds of inactivity.
At and
or if it should display upside-down.
At you can reset to ex works setting. Please push the UP and DOWN buttons at the same time. The
display shows

DMX-mode

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button to select the DMX mode and the display shows
You can select the desired addresses via the UP or DOWN buttons.
Controlling:
After having addressed the device, you may now start operating it via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
no data received at the DMX-input, the control display flashes. This function is only available if the display
mode under Other was set to
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective.
- the cable or connector is defective or the signal cable is not well connected.
DMX Channel Selection: Choosing a DMX Channel Mode
After having set the desired address, you can now choose a DMX Channel Mode. (2 CH, 3 CH, 4 CH, 5 CH).
Please press the SET UP button until the display shows
Set the desired mode via the UP or DOWN buttons.

DMX-protocol

2-channel mode:
In this mode, the last possible starting address is 511.
CH Value
1 000~255
2 000~255
3-channel mode:
In this mode, the last possible starting address is 510.
CH Value
1 000~255
2 000~255
3 000~255
via the UP or DOWN buttons, you can decide if the display should always be on, or
via the UP or DOWN buttons, you can decide if the display should display normally,
and the color switching programs begins to run.
.
Function
White (0-100%)
Amber (0-100%)
Function
White (0-100%)
Amber (0-100%)
Dimmer (0-100%)
/ /
23/25
~ .
/ .
00062196, Version 1.3