Electrolux ESF 43020 Benutzerinformation Seite 83

Fault code and malfunction
• continuous flashing of the start/cancel indica-
tor light
• 2 flashes of the End indicator light
The dishwasher will not drain
• continuous flashing of the start/cancel indica-
tor light
• 3 flashes of the End indicator light
Anti-flood device is activated
Malfunction
The programme does not start
Once these checks have been carried out
switch on the appliance.
The programme will continue from the point
at which it was interrupted.
If the malfunction or fault code reappears
contact your local Service Force Centre.
For other fault codes not described in the
above chart, please contact your local Serv-
ice Force Centre.
Contact your local Service Force Centre,
quoting the model (Mod.), product number
(PNC) and serial number (S.N.).
The dishes are not
clean
The dishes are wet
and dull
There are streaks,
milky spots or a blu-
ish coating on
glasses and dishes
The wash results are not satisfactory
• The wrong programme has been selected.
• The dishes are arranged in such a way as to stop water reaching all parts
of a surface. The baskets must not be overloaded.
• The spray arms do not rotate freely due to incorrect arrangement of the
load.
• The filters in the base of the washing compartment are dirty or incorrectly
positioned.
• Too little or no detergent has been used.
• Where there are limescales deposits on the dishes; the salt container is
empty or incorrect level of the water softener has been set.
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
• Rinse aid was not used.
• The rinse aid dispenser is empty.
• Decrease rinse aid dosage.
Possible cause and solution
• The sink spigot is blocked
Clean out the sink spigot
• The water drain hose has not been correctly laid
or it is bent or squashed
Check the water drain hose connection
Close the water tap and contact your local Service
Force Centre.
Possible cause and solution
• The dishwasher door has not been properly
closed.
Close the door.
• The main plug is not plugged in.
Insert the main plug
• The fuse has blown out in the household fuse
box.
Replace the fuse.
• Delay start has been set. If dishes are to be
washed immediately, cancel the delay start.
This information can be found on the rating
plate located on the side of the dishwasher
door.
So that you always have these numbers at
hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
electrolux 83