Electrolux ESF 2200 DW Benutzerinformation Seite 12

12 electrolux
Problem
The programme does not start.
The appliance does not fill with
water.
The appliance does not drain
the water.
The anti-flood device is on.
After the check, activate the appliance. Set
and start the programme again.
If the problem occurs again, contact the
service centre.
If other alarm codes show, contact the
service centre.
THE WASHING AND THE DRYING RESULTS ARE NOT SATISFACTORY
Problem
The dishes are not clean.
Possible cause
The mains plug is not connec-
ted in the mains socket.
The appliance door is open.
The fuse in the fuse box is
damaged.
The delay start is set.
The water tap is closed.
The water pressure is too low.
The connection of the water in-
let hose is not correct.
The water inlet hose is dam-
aged.
The connection of the water
drain hose is not correct.
The filters are clogged.
Kitchen sink is clogged.
The necessary information for the service
centre is on the rating plate.
Record this information:
– Serial number
(SN.) ..............................................
Possible cause
The selected programme was
not applicable for the type of
load and the degree of soil.
The basket was not loaded
correctly, water did not touch
all surfaces.
The spray arm could not turn
freely because of incorrect ar-
rangement of the load.
The filters are clogged.
The filters are not correctly as-
sembled and installed.
Possible solution
Connect the mains plug.
The appliance door is open.
Replace the fuse.
Cancel the delay start or wait
until the countdown is comple-
ted.
Open the water tap.
Contact your local water au-
thority.
Make sure that the connection
is correct.
Make sure that the water inlet
hose has no damages.
Make sure that the connection
is correct.
Make sure that the filters are
clean.
Make sure that the kitchen sink
drains correctly, if not contact a
plumber.
Close the water tap and con-
tact the service centre.
Possible solution
Make sure that the programme
is applicable for the type of load
and the degree of soil.
Load the basket correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arm.
Make sure that the filters are
clean.
Make sure that the filters cor-
rectly assembled and installed.