34 www.electrolux.com
7. TROUBLESHOOTING
You cannot activate the
appliance or operate it.
An acoustic signal
sounds and the appliance
deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
The appliance deacti-
vates.
The residual heat indica-
tor does not come on.
There is no signal when
you touch the panel sen-
sor fields.
comes on
comes on
and number come on. There is an error in the
If you tried the above solutions and can-
not repair the problem, speak to your
Problem
Possible cause
The appliance is not con-
nected to an electrical
supply or it is connected
incorrectly.
You touched 2 or more
sensor fields at the same
time.
There is water or fat
stains on the control pan-
el.
You put something on
one or more sensor fields.
You put something on the
sensor field
.
The roasting zone is not
hot because it operated
only for a short time.
The signals are deactiva-
ted.
The Automatic Switch Off
operates.
The Child Safety Device
or the Lock function op-
erates.
appliance.
dealer or the Customer Care Department.
Give the data from the rating plate, three-
Remedy
Check if the appliance is
correctly connected to
the electrical supply (refer
to connection diagram).
Activate the appliance
again and set the heat
setting in less than 7 sec-
onds.
Touch only one sensor
field.
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the roasting zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
Activate the signals (refer
to "OffSound Control").
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
Disconnect the fuse from
the electrical system of
the house in order to dis-
connect the appliance
from the electrical supply
for some time. Connect it
again. If
comes on
again, speak to the serv-
ice centre.