Chain Maintenance; Storage And Transportation; Ordering Replacement Parts; Disposal And Recycling - EINHELL GC-PC 1235/1 Originalbetriebsanleitung

7.2.6 Chain maintenance

Chain sharpening
Note: A sharp chain produces well-defi ned chips.
When your chain starts to produce sawdust, it is
time to sharpen.
Chain sharpening requires special tools to ensure
that cutters are sharpened at the correct angle
and depth. For the inexperienced chain saw user,
we recommend that the saw chain be professio-
nally sharpened by the nearest professional Ser-
vice Center. If you feel comfortable sharpening
your own saw chain, special tools are available
from the professional Service Center.
Chain sharpening (Fig. 18)
Sharpen the chain using protective gloves and a
round fi le of.
Always sharpen the cutters only with outward
strokes (Fig. 19) observing the values given in
Fig. 18.
After sharpening, the cutting links must all have
the same width and length.
After the blades have been sharpened 3-4 times,
check the height of the depth limiter and if neces-
sary lower it with a fl at fi le and then round off the
front corner (Fig. 20).
Round off the front edges with a fi le.

7.3 Storage and transportation

Install the chain guard (4) before transporting or
storing the chainsaw.
Note: Never put a chain saw into storage for
longer than 30 days without carrying out the fol-
lowing steps.
Storing a chain saw
Storing a chain saw for longer than 30 days re-
quires storage maintenance. Unless the storage
instructions are followed, fuel remaining in the
carburetor will evaporate, leaving gum-like depo-
sits. This could lead to diffi cult starting and result
in costly repairs.
1. Remove the fuel tank cap slowly to release
any pressure in tank. Carefully drain the fuel
tank.
2. Start the engine and let it run until the unit
stops to remove fuel from carburetor.
3. Allow the engine to cool (approx. 5 minutes).
4. Thoroughly clean the saw.
Anl_GC_PC_1235_I_SPK1.indb 31 Anl_GC_PC_1235_I_SPK1.indb 31
GB
Note: Store the unit in a dry place and away from
possible sources of ignition such as a furnace,
gas hot water heater, gas dryer, etc.
After the saw has been in storage, perform the
steps listed in Paragraph 5 before starting the
chainsaw.
Transportation
•
Engage the chain brake.
•
Make sure the chainsaw cannot shift position
in order to prevent fuel loss, damage or injury.

7.4 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 31 -
30.06.2016 15:13:44 30.06.2016 15:13:44