F) Selection Of The Temperature Sensor; G) Frost Alarm - Renkforce 1423363 Bedienungsanleitung

Snooze function (snooze)
• When the alarm signal sounds, briefly push the button "SNOOZE/LIGHT" (A2) on the
top of the projection radio alarm clock. The respective symbol D2 or D3 will flash.
The alarm signal is interrupted for approx. 5 minutes and then restarted.
You can repeat this as often as you like.
• Terminate the snooze function prematurely by briefly pushing the button "ALARM"
(A6). The respective symbol D2 or D3 will stop flashing.
Stopping the alarm signal
• When the alarm sounds at the set alarm time, it can be ended by briefly pushing the
button "ALARM" (A6).
• If no button is pushed, the alarm signal will be ended automatically after 2 minutes.

f) Selection of the temperature sensor

• Briefly push the button "+/CHANNEL" (A7), to switch between the three channels for
the outdoor sensors. The standard channel is 1.
To the left of the display for the measured values of the outdoor sensor (C10),
the respective active channel number will appear.
• To automatically display all three channels for approx. 3 seconds in sequence, keep
the button "+/CHANNEL" (A7) pushed for approx. 3 seconds until a sound signal is
emitted. Release the button again.
• To terminate automatic mode, briefly push the button "+/CHANNEL" (A7) again.
• The reception level is displayed using the bar chart C9. If no bars are displayed, the
sensor has either not been found or the connection has been interrupted.

g) Frost alarm

• If the outdoor temperature drops to below 3 °C to -2 °C, the display will indicate the
frost alarm(C8) and flash evenly.
• The symbol will disappear again once the temperature climbs over 3 °C or drops
below -2 °C.
56