Bauknecht DTLG 9010 Benutzerhandbuch Seite 20

DESCRIPTION AND USE OF HOOD
(Figure 13)
1. Control panel
2. Front panel
3. Grease filters
4. Carbon filters (Filter Version only)
5. Lighting
CONTROL PANEL (Figure 14)
The hood has a "TOUCH" device for control of lights and speed.
For correct use, carefully read the instructions below.
• Button T1:
Delays hood switch-off, timing the set speed for a few minutes.
With this function, the hood switches off at the end of the time. Operation times are as follows:
• extraction speed (power) 1: 20 minutes.
• extraction speed (power) 2: 15 minutes.
• extraction speed (power) 3: 10 minutes.
• extraction speed (power) 4: 5 minutes.
Press button T2 or T3 and the hood exits timed mode and the extraction speed (power) decreases or increases depending on the button pressed. During the
timing stage, the LED corresponding to the speed blinks.
IMPORTANT: When operating the timer, the hood might switch to a lower intake speed (power) before turning off, as on some speeds there is already a timing
on the speed reduction itself.
• Button T2:
Decreases the active extraction speed (power) (4 → 3 → 2 → 1 → OFF). The speed is displayed by lighting up of the LED corresponding to the speed.
Button T2 has no effect on extraction panel opening/closing.
• Button T3:
Increases the active extraction speed (power) (1 → 2 → 3 → 4). The speed is displayed by lighting up of the LED corresponding to the speed.
IMPORTANT: If the panel is closed (hood off), button T3 firstly operates extraction panel opening and then sets the hood to extraction speed (power) 1.
• Button T4:
Switches on the light.
IMPORTANT: If the extraction panel is closed (hood off), button T4 firstly operates extraction panel opening and then switches on the light.
• Button T5:
Opens (lifts) and closes (lowers) the extraction panel.
With the hood off and panel closed, button T5 firstly opens the extraction panel and then sets the hood to extraction speed (power) 1.
With the hood on (at any speed) and panel open, button T5 firstly switches the hood off (also switching off the lights, if on) and then closes the extraction
panel.
IMPORTANT: Use the highest speed setting for particularly concentrated steam and fumes. It is advisable to activate extraction 5 minutes before starting
cooking and leave it on for about another 15 minutes at the end of cooking.
Additional information on operation
When removing the front panel for cleaning and maintenance operations, all electronic extraction and movement functions are blocked.
Antipinching system: whenever an obstacle hinders closing of the Downdraft, closing stops and the extraction panel goes up.
Grease filter saturation signalling
Every 40 hours of use, the hood signals the need for grease filter maintenance. Signalling occurs with all the extraction speed (power) LEDs blinking at the same
time.
Grease filter signalling reset: after carrying out grease filter maintenance, press button T1 for more than 3 seconds to reset the signalling.
IMPORTANT: Signalling is not displayed with the hood OFF, regardless of the position of the extraction panel.
IMPORTANT: (only for models fitted with a motor or a remote GME 22):
Suction speed 4 (power) is timed for 6 minutes, after which the hood will automatically switch to suction speed 3 (power).
GB20
Fig. 13
Fig. 14